WHY YOU SHOULD TEST YOUR POOL WATER

If you’re planning to install or rather build a pool in your home, you must be prepared to properly maintain and care for it. Proper pool maintenance practices range from cleaning to maintaining a water balance throughout the day. You need to test your pool water weekly by yourself and at least once a month by a professional. Frequent testing of your pool water will help in ensuring the pool is safe for use. Here are reasons why you need to test your pool’s water regularly.

Ensuring proper water balance

Chemical levels such as pH, acidity or alkalinity affect directly the comfort level of those using the pool. A pH between 7.2 and 7.6 is not only good for the skin and eyes but also prevents rashes that occur in pools with low PH. Total alkalinity prevents “pH bounce” in the event that chemicals like chlorine are added.

Ensure bather safety

You need to ensure that your pool water is healthy and safe for everyone coming in to swim. This will prevent heath issues resulting from algae, bacteria and other microbes that could be harboring in the pool water. If the water is not kept safe, those using the pool may develop ear, nose and throat infections. There are several ways through which your pool can get contaminated including spilling things in the pool, debris falling into the pool, pets splashing into the pool and wildlife and insects drowning in the pool. All these can compromise the safety of your pool water.

Pool equipment preservation

Most people tend to ignore the aspect of adding chemicals to preserve their pool equipment. There are certain chemicals that help in preserving pool components which means when they are not added, the components would be at risk of wearing down. Pool water tries to balance itself naturally. However, whenever there’s a reduction in the level of calcium, the pool water might end up pulling calcium from the vinyl liner and pool walls. What do you expect? Your pool will experience staining and scaling thereby damaging structural integrity of your walls or liner. Overlooking the water testing and the chemicals needed in your pool should, therefore, never be an option. Thanks to Heritage Pools for help with information on this article (pool cleaning charleston sc)

VACUUMING A POOL

Vacuuming is one of the ways of getting rid of the gunk on the bottom of your pool and the microscopic algae spores that have not been captured by your filtration system. Skimming only removes the debris, leaves, and dirt floating on your pool. As a matter of fact, most of these debris and dirt only floats on your pool for about four hours before sinking to the bottom. That explains why you must vacuum your pool at least once every week to remove of the dirt and debris at the bottom of your pool.

Most people prefer using an automatic pool cleaner but other consider cleaning manually using basic cleaning equipment. If you’re doing it manually, these steps can help you vacuum an in-ground or above ground swimming pool.

  • After you’ve removed the large debris and leaves, attach the vacuum head to the pole and the hose. Use a scoop net to get rid of the large debris and leaves. You don’t want the debris to block your hose pipe or vacuum head when vacuuming the pool.
  • Go ahead and lower the vacuum head to the pool bottom. Remember to flood the hose pipe with water to get rid of any trapped air. Another of removing air from the hose is using a hand-over-hand method to sink the hose as you work from the part attached to the vacuum head towards the free end.
  • Attach the hose pipe to the opening at the back of the skimmer. Make sure the main control valve is turned off and the pump is activated and running smoothly. There are pools that have a dedicated suction port. If your pool has such a port, then attach the hose it instead of the skimmer. Note that you’ll have to remove the skimmer basket before attaching the hose pipe.
  • Use the telescopic pole to move the vacuum the same way you would a real vacuum on a carpet. This should be done slowly and deliberately across the sides of the pool as well as its bottom. You may need to empty the pump strainer while cleaning if the pool is extremely dirty.
  • Make sure the vacuum head stays at the pool sides or bottom until you’ve opened any of the valves you had closed at the filter slab.
  • You may now go ahead and disconnect the hose from the dedicated suction port or skimmer.